Canon Booklet Finisher-D1 Service Manual page 139

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Rear Alignment Motor > Procedure
CAUTION: When placing the Process Upper Tray [1] on a paper stack [2], be sure to
note the following points.
• Place the Process Upper Tray [1] and a paper stack [2] horizontal to the floor.
• Be sure to keep the clearance [A] between the 2 Process Bins [3] and surface of the
floor when placing it.
[3]
[2]
1) Remove the belt [1].
• 1 Screw [2] (to loosen)
• 1 Pulley [3]
2) Put a stack of paper [4] to place the Process Upper Tray [5].
[3]
[1]
[4]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Rear Alignment Motor > Procedure
[1]
[3]
[A]
[2]
[2]
[5]
F-4-180
3) Remove the Rear Alignment Motor [1].
• 1 Wire Saddle [2]
• 1 Connector [3]
• 2 Screws [4]
F-4-179
[2]
[4]
[1]
x2
4-76
[3]
[4]
F-4-181
4-76