Canon Booklet Finisher-D1 Service Manual page 93

4
Parts Replacing and Cleaning > Stacking Assembly > Removing the Stack Wall (Lower) > Procedure
CAUTION:
The [A] part of the Neat Stack Unit (Lower) Cover [1] controls the ascent of the Tray B
[2]. When the Neat Stack Unit (Lower) Cover [1] is removed, be sure to avoid hitting the
following parts on the upper side by lifting the Tray B [2].
• [4] Neat Stack Unit (Lower)
• [5] Tray A
• [6] Neat Stack Unit (Upper)
[1]
[A]
[2]
4 Parts Replacing and Cleaning > Stacking Assembly > Removing the Stack Wall (Lower) > Procedure
[6]
[5]
[4]
[2]
F-4-47
NOTE:
Because of the different procedures depending on whether the Saddle Unit is attached,
be sure to follow the steps for the appropriate model.
• Model with Saddle Unit: Steps 3 and 4
• Model without Saddle Unit: Step 5
3) Lower the shutter [1], and remove the 2 screws [2].
4) Remove the Stack Wall (Lower) [3].
• 5 Screws [4]
x2
[1]
[2]
5) Remove the Stack Wall (Lower) [1].
• 7 Screws [2]
x7
[1]
4-30
x5
[3]
[4]
F-4-48
[2]
[2]
F-4-49
4-30