5.2
Verifying Devices Supporting iQSS Against
System Configuration
The system configuration displayed in the "CC IE Field Configuration" window can be verified against the slave stations
connected to a CC-Link IE Field Network master/local module.
The result is displayed in the "Verification Result of the Configuration with the Connected Module" window.
Verify a system configuration when it is manually created or edited.
This function can be performed to a device supporting iQSS, which is connected to a bridge module
(NZ2AW1GFAL).
Operating procedure
■Verification of a device supporting iQSS connected to a bridge module (NZ2AW1GFAL).
2. Check
3. Click
• The display is switched by right-clicking on the "Verification Result of the Configuration with the Connected
Module" window and selecting "Display All"/"Display Mismatch Only"/"Display other than Match".
• The cursor jumps to the corresponding location in the "CC IE Field Configuration" window by double-clicking
the row with "Mismatch" in the "Verification Result of the Configuration with the Connected Module" window.
■Verification methods of system configuration information
The system configuration information of AnyWireASLINK can also be verified by either of the following operations.
• Click the [Verify] button in the "AnyWireASLINK Configuration" window.
• Select [Online] [Verification of the Configuration with the Connected Module] in MELSOFT Navigator.
For the operation methods of MELSOFT Navigator, refer to the following manual.
(Let's start iQ Works Version 2)
5 CC-Link IE Field Network
104
5.2 Verifying Devices Supporting iQSS Against System Configuration
1. Select
1.
Select [AnyWireASLINK Configuration] [Online]
[Verification of the Configuration with the Connected Module]
in the "AnyWireASLINK Configuration" window.
2.
When an automatic address detection is required, select the
"Execute Verification of the Configuration with the Connected
Module after Address Auto-recognition" checkbox, then click
the [Yes] button.
For a case in which an automatic address detection is required,
refer to the following manual.
MELSEC-Q/L AnyWireASLINK Master Module User's Manual
The verification results are displayed in the "Verification Result of
the Configuration with the Connected Module" window.