Mitsubishi Electric IQSS-R-E Reference Manual page 105

1. Check
2. Click
Select
■Detection method of a system configuration
A system configuration of a device supporting iQSS, which is connected to a bridge module (NZ2AW1GFAL), can also be
detected by either of the following operations.
• Click the [Detect Now] button in the "AnyWireASLINK Configuration" window.
Considerations when detecting devices connected to a bridge module
■Automatic address detection
When the actual system configuration was changed, perform the automatic address detection before using an iQ Sensor
Solution function.
The automatic address detection is performed by setting a CPU module to the STOP status and pressing the SET switch
(automatic address detection switch) on a bridge module (NZ2AW1GFAL).
By pressing the SET switch (automatic address detection switch), information in a bridge module (NZ2AW1GFAL) is updated
at once.
For details on the automatic address detection, refer to the following manual.
CC-Link IE Field Network-AnyWireASLINK Bridge Module User's Manual
■Address setting for a device supporting iQSS
To detect the devices supporting iQSS which are connected to a bridge module (NZ2AW1GFAL), configure the setting
required for communication (such as address setting and amplifier teaching) in advance.
Make sure that the address occupied by a device supporting iQSS is set so as not to exceed the number of transmission
points set for a bridge module (NZ2AW1GFAL).
(CC-Link IE Field Network-AnyWireASLINK Bridge Module User's Manual)
4.
When an automatic address detection is required, select the
"Execute Detect Now after Address Auto-recognition"
checkbox, then click the [Yes] button.
For a case in which an automatic address detection is required,
refer to the following manual.
MELSEC-Q/L AnyWireASLINK Master Module User's Manual
The device supporting iQSS of AnyWireASLINK, which is
connected to a bridge module (NZ2AW1GFAL), is displayed in the
"AnyWireASLINK Configuration" window.
5.
Select [AnyWireASLINK Configuration]  [Close with
Enabling the Setting] in the "AnyWireASLINK Configuration"
window.
The setting of the "AnyWireASLINK Configuration" window is
enabled and the window is closed.
5.1 Detecting Devices Supporting iQSS Automatically
5 CC-Link IE Field Network
5
103