Monitoring Devices Supporting Iqss - Mitsubishi Electric IQSS-R-E Reference Manual

4.4

Monitoring Devices Supporting iQSS

The connection statuses of devices supporting iQSS can be monitored.
Operating procedure
1. Check
2. Click
Select
Sensor/device monitor reads a large volume of information from a CPU module at once.
Therefore, the processing speed of the sensor/device monitor function may decrease depending on the set
communication route.
4 CC-Link
66
4.4 Monitoring Devices Supporting iQSS
1. Select
2. Select
3. Click
List of stations
Device map area
Monitoring Information
window
1.
Select [Diagnostics]  [Sensor/Device Monitor] with an
engineering tool.
2.
Select a CC-Link master/local module in the "Module
Selection (Sensor/Device Monitor)" screen, and click the [OK]
button.
3.
Read the message and select the "Set the Module
Connected to the Communication Module also as the Read
Object" checkbox, then click the [Yes] button.
In any of the following cases, select the "Set the Module
Connected to the Communication Module also as the Read
Object" checkbox.
• The automatic detection function of connected devices is used
for the first time.
• The CPU module was reset or turned OFF.
• The actual system configuration was changed.
The "Sensor/Device Monitor for CC-Link" screen appears.
4.
Select a target device supporting iQSS to be monitored in
'List of stations' or 'Device map area' in the "Sensor/Device
Monitor for CC-Link" screen.
The status of the selected device supporting iQSS is displayed in
the "Monitoring Information" window.