Mitsubishi Electric IQSS-R-E Reference Manual page 289

Backup folder/file
New backup folders are created in the 'Ethernet' folder which exists in the 'Backup' folder under the main folder of
'$MELPRJ$' in an SD memory card when data is backed up.
If no '$MELPRJ$' folder, 'Backup' folder, or 'Ethernet' folder exists, each of the folders are created as well when data is backed
up.
Up to 100 backup folders (date_number) can be created in the 'Ethernet' folder.
■Backup folder configuration
The following figure shows the backup folder configuration in an SD memory card.
/
$MELPRJ$ Backup
(1) A folder to save the settings of devices supporting iQSS connected toEthernet
(2) Backup folder (date_number)
(3) Backup folder (target module_IP address)
(4) Backup folder (information of devices supporting iQSS for each IP address)
■Backup folder name
• Date_Number
YYYYMMDD_**
YYYY: Year when the data was backed up (four digits in decimal)
MM: Month when the data was backed up (two digits in decimal)
DD: Day when the data was backed up (two digits in decimal)
**: Number (two digits in decimal (00 to 99))
*1 The date of a backup folder name can be changed arbitrary. However, the folder name should be set within 64 characters.
*2 If multiple folders with the same number exist while a target folder (0 to 99) is set to SD1363 (iQ Sensor Solution backup/restoration
folder number setting), the date of the backup folder name may not be updated. (Setting a number for a data backup folder name)
• Target module_IP address
03FF_****
03FF: Target module (four digits in hexadecimal) (03FF: Built-in Ethernet)
****: IP address (eight digits in hexadecimal)
Ex.
When IP address of the device supporting iQSS is 192.168.3.40, '03FF_C0A80328' will be the backup folder name (target
module_IP address).
1 9 2 . 1 6 8 . 3 . 4 0
03FF_C0A80328
C0h A8h 03h 28h
(1)
Ethernet 20160101_00
20160101_01
20160102_02
*1
*1
*1
*2
(2) (3)
XXXXXXXX
03FF_0A615F00
XXXXXXXX
$BKUP_UNIT_INF.BSI
XXXXXXXX
03FF_0A615F28
XXXXXXXX
$BKUP_UNIT_INF.BSI
XXXXXXXX
03FF_0A615F35
XXXXXXXX
$BKUP_UNIT_INF.BSI
10.5 Backing up/Restoring Data of Devices Supporting iQSS
10
(4)
XXXXXXXX
XXXXXXXX
XXXXXXXX
10 Ethernet
287