Data restoration
Information saved in an SD memory card can be restored to a device supporting iQSS for each ID by using an engineering
tool.
Operating procedure
1. Select
2. Click
The initial value of the restoration setting (SD1444) is as follows:
• Lower 8 bits of SD1444 (operation setting on error): 0H (continue)
Use a program when restoring data with the settings other than above. (Page 46 Program execution for
data restoration)
2. Select
1. Select
1.
Select a target device supporting iQSS in 'List of modules' or
'Device map area' in the "AnyWireASLINK Configuration"
window, and select [AnyWireASLINK Configuration]
[Online] [Restore Slave Module].
2.
Select backup data to be restored, and click the [Execute]
button.
A list of the backup folder names (date_number) is
displayed in the column of "Folder Name".
Backup data is stored in backup folders for each
folder name (Start I/O number_I/O type_ID
number) in an SD memory card.
For details on the backup folder configuration,
refer to the following section.
Page 34 Backup folder configuration
3.
Read the message, and click the [OK] button.
Data is restored.
3.5 Backing up/Restoring Data of Devices Supporting iQSS
3 AnyWireASLINK
45
3