Mitsubishi Electric IQSS-R-E Reference Manual page 272

■Setting the restoration setting
1.
Setting a target module type
Set a target module with the lower 8 bits of SD1362 (iQ Sensor Solution data backup/restoration target module, execution unit
setting).
Target module type
4H: CC-Link IE Field Network
2.
Setting an execution unit
Set a unit to specify the range of data to be restored at once.
Specify the execution unit to the upper 8 bits of SD1362.
Execution unit
1H: Module unit
2H: Station unit
3H: Station sub-ID unit
3.
Selecting a folder for data restoration
Set a folder number to SD1363 (iQ Sensor Solution backup/restoration folder number setting).
Target folder
0 to 99: Target folder specification
4.
Setting a target device
• Setting a module
When '1H' (module unit) is set for the execution unit, set a start I/O number to SD1364 (iQ Sensor Solution data backup/
restoration target setting (target module)).
In a multiple CPU system, only the CC-Link IE Field Network master station controlled by a host CPU can be restored. Data
restoration cannot be performed for non-controlled modules.
Target device (Module)
0 to FFH: Start I/O number
• Setting a station number
When '2H' (station unit) or '3H' (station sub-ID unit) is set for the execution unit, set a station number to SD1365 (iQ Sensor
Solution data backup/restoration target setting (target device 1)).
Target device (Station number)
1 to 120: Station number
• Setting a station sub-ID number
When '3H' (station sub-ID unit) is set for the execution unit, set a station sub-ID number to SD1366 (iQ Sensor Solution
backup/restoration target setting (target device 2)).
Target device (Station sub-ID
number)
0 to 9999: Station sub-ID number
When backup/restore the data in a device supporting iQSS which is connected to a bridge module
(NZ2AW1GFAL), set the ID number of AnyWireASLINK to SD1366.
9 CC-Link IE Field Network
270
9.4 Backing up/Restoring Data of Devices Supporting iQSS
Description
Set this to specify a device supporting iQSS which is connected to the CC-Link IE Field Network master station.
Description
Set this to specify the device supporting iQSS which is connected to the own network among the devices which
are connected to a CC-Link IE Field Network master station with the specified start I/O number.
Set this to specify either of the following iQSS supported devices which are connected to a CC-Link IE Field
Network master station with the specified start I/O number: the devices supporting iQSS with the specified
station number or all the devices supporting iQSS which are connected to the specified station number.
Set this to specify the following devices supporting iQSS which are connected to a CC-Link IE Field Network
master station with the specified start I/O number: the devices which are connected to the specified station
number with the specified station sub-ID number.
Description
Specify a number (0 to 99) of the backup folder name to be restored.
Description
Set the start I/O number (the value obtained by dividing the start I/O number by 16) of the CC-Link IE Field
Network master station which is connected to a target device supporting iQSS.
Description
Set the station number of a target device supporting iQSS or the station number of the module which is
connected to a device supporting iQSS.
Description
Set the station sub-ID number of a target device supporting iQSS.