Hitachi Compute Blade 2000 User Manual page 83

D Fibre channel (FC) interface connectors: 0 - 5
These connectors are equipped with optical modules: small form-factor
pluggable plus (SFP+).
Connect a Fibre-channel cable to this optical module.
E FC port diagnosis LED: orange
Shows a diagnosis of a FC port status.
Lights solid orange when a signal is received but not on line.
Blinks slowly when the port is disabled due to the disable setting with a
command, or under diagnosis.
Blinks orange rapidly when the port fails.
Both FC port diagnosis LED and FC port status LED are turned off when no
signal is received.
F FC port status LED: green
Shows a FC port status.
Lights solid green online. Blinks green when the link is active.
Blinks green slowly when the port is online but segmented.
Blinks green rapidly when the port is diagnosed with the internal loopback.
Both FC port diagnosis LED and FC port status LED are turned off when no
signal is received.
G USB connector
(for optional USB memory devices dedicated to the Fibre-channel)
To use an optional USB memory device, connect it to this connector.
Do not connect any devices other than USB memory devices dedicated to the
Fibre-channel to this connector.
H LAN interface connector
LAN for managing Fibre-channel switch modules.
This LAN port is disabled during shipment.
Management LAN for the Fibre-channel switch module can be connected to
the LAN port of the management module or to this LAN port, which can be
switched via the management module system console.
I LAN interface status LED1: orange
Lights solid orange online. Blinks orange when the link is active.
J LAN interface status LED2: green
Lights solid green at 1000 Mbps full duplex.
32