Standard Server Blade Settings (X55A1/X55A2/X55R3/X55S3/X55R4 Models); Initial Settings With Server Blade Web Console - Hitachi Compute Blade 2000 User Manual

Standard server blade settings
(X55A1/X55A2/X55R3/X55S3/X55R4
models)
This section describes the standard server blade setup with the Web console.
See Standard server blade setup menu
(X55A1/X55A2 models)
(X55R3/X55S3/55R4 models)
Initial settings with server blade web
console
A server blade can be managed remotely by using the server blade web console.
This section describes how to perform initial settings of the server blade via the
server blade web console.
The following items require initial settings:
User account configuration

Logical partition (LPAR) manager boot settings

Mouse mode settings for the remote console

Baseboard Management Controller (BMC) time settings

 Connection
Connect to the server blade Web console via the management network of the
management module. See "External Interface of the Management Module" in
Chapter 6 for information about how to connect to the network.
Confirm that the client web browser is properly configured before using the server
blade Web console. If the settings are not appropriate, the server blade Web console
will not work properly.
To use the server blade Web console, you need one of the web browsers shown in
the following table.
#
1 Internet Explorer 6.0 or later* (Browser tabs are not available.)
2 Firefox 2.0 or later
* When connecting to the server blade Web console using TLS v1.1/1.2, use
Windows 7 or later, or Windows Server 2008 R2 or later.
1 Disable the pop-up blocker of the client web browser to enable the pop-up
windows. If there are other pop-up-blocker-like features, those features also
need to be disabled.
2 Enable JavaScript.
or Standard server blade setup menu
for the basic input/output system (BIOS) menu.
Web browser
76