Hitachi Compute Blade 2000 User Manual page 449

26 This is a TEST message. Press any key to ignore
it, or wait 5 seconds. No further action is required.
Press any key to continue, or press C to load the
configuration utility.
27 This firmware is an ALPHA version. It has not
completed all validation.
28 This firmware is a BETA version. It has not
completed all validation.
29 This firmware is a TEST version. It has not
completed any validation.
30 The firmware version inconsistency was detected.
The adapter was recovered, but cached data was
lost. Press any key to continue or press C to load
the configuration utility.
31 Firmware Failed Validation. Adapter needs to be
reflashed.
32 The most recent configuration command could
not be committed and must be retried. Press any
key to continue, or press C to load the
configuration utility.
33 Previous configuration cleared or missing.
Importing configuration created on X/Y X:Y. Press
any key to continue or press C to load the
configuration utility.
34 An enclosure was found that contains both SAS
and SATA drives, but this controller does not
allow mixed drive types in a single enclosure.
Correct the problem and restart your system.
Press any key to continue or press C to load the
configuration utility.
35 SAS drives were detected, but this controller does
not support SAS drives. Remove the SAS drives
and restart your system. Press any key to
continue or press C to load the configuration
utility.
36 SATA drives were detected, but this controller
does not support SATA drives. Remove the SATA
drives, and restart your system.
Press any key to continue or press C to load the
configuration utility.
37 Raid Key Missing. Please check the Raid Key
connection. If problems persist contact Technical
Support.
38 Raid Key Authentication Error. Please check the
RAID Key installed for this solution. If problems
persist contact Technical Support.
39 Raid Key OEM Authentication Error. Install the
correct RAID key for this System. If problems
persist, contact Technical Support.
40 There are more enclosures connected to the port
than what is allowed for a single SAS port.
Remove the extra enclosures, and then restart
your system.
Message
398
Description
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
Disk array configuration information was cleared or
not found. When this message is displayed,
contact your reseller or call maintenance
personnel.
The disk array controller is operated by incorrect
parameters. When this message is displayed,
contact your reseller or call maintenance
personnel.
Incorrect enclosures are detected. When this
message is displayed, contact your reseller or call
maintenance personnel.