Hitachi Compute Blade 2000 User Manual page 248

Building disk arrays
This section describes the procedure for building disk arrays.
The building of disk arrays should be entirely performed from the Configuration
Wizard.
You must not change the disk array during system operations. If you do, all
data will be lost from those disks due to change in the disk array.
!
Make sure to set each item in the recommended value
Note
unless other specific directions are given. Otherwise, the
system may not properly operate. Hitachi Data System is
not responsibile for a malfunction due to changed settings
other than our recommended values.
Building disk arrays for RAID 0, 1, 5, and 6
This section describes the procedure for building new disk arrays for Redundant
Arrays of Independent Disks (RAID) 0, 1, 5, and 6.
To build RAID 10, see
For information about how to set hotspare, see
hotspares.
1 Select Configuration Wizard from the main menu. The following screen
appears.
NOTICE
Building disk arrays for RAID
197
10.
Setting