Reel Assembly Removal And Installation - Toro 04384 Service Manual

Reel Assembly Removal and Installation

8
12
10
11
Grease OD
surface
RIGHT
FRONT
1. Crossmember
2. LH side plate
3. Flange head screw (2 used)
4. Shoulder bolt (2 used per side plate)
5. Flange nut (2 used per side plate)
6. Cutting reel assembly
NOTE: This section provides the procedure for remov-
ing and installing the cutting reel assembly (cutting reel,
flocked seals, reel bearings, bearing lock screw and reel
nut) from the cutting unit. Refer to Reel Assembly Ser-
vice later in this section for information on servicing the
cutting reel assembly.
DPA Cutting Units
210 to 240 in- -lb
(24 to 27 N- -m)
4
9
5
6
Grease OD
surface
7. O- -ring
8. Cap screw (2 used)
9. RH side plate
10. Weight
11. Hex nut (4 used)
13
5
5
14
Figure 21
NOTE: Removal of the cutting reel requires removal of
the LH side plate from the cutting unit crossmember.
The RH side plate does not have to be removed from the
frame when using the following procedure.
NOTE: Figure 21 shows components when the hydrau-
lic reel motor is on the left side of the cutting unit.
Page 7 - - 20
210 to 240 in- -lb
(24 to 27 N- -m)
1
5
4
2
7
11
15
3
16
12. O- -ring
13. Grass shield
14. Flat wire spring
15. Reel motor adapter
16. Socket head screw (2 used)
Greensmaster 3250--D