Toro 04384 Service Manual page 191

Disassembly
1. Park machine on a level surface. Make sure engine
is off and parking brake is engaged.
2. Remove cutting unit from front lift arm.
3. Disassemble front lift arm as needed using Figures
11 and 12 as guides.
Assembly
1. Assemble front lift arm using Figures 11 and 12 as
guides.
A. If clevis (item 16 in Fig. 11) was removed from
front lift frame, torque cap screw from 67 to 83 ft- -lb
(91 to 112 N- -m).
B. If pull frame (item 1 in Fig. 12) was removed from
clevis on lift frame, torque cap screw from 67 to 83
ft- -lb (91 to 112 N- -m).
2. Attach cutting unit to lift arm.
3. Check that when raised to the transport position, the
cutting units are secured by the transport plate. If neces-
sary, loosen two (2) cap screws (item 28 in Fig. 11) and
reposition transport plate.
Greensmaster 3250--D
2
1
3
1. Pull frame
2. Pivot spacer
3. Bushing
Page 6 - - 15
67 to 83 ft- -lb
5
(91 to 112 N- -m)
4
3
6
Figure 12
4. Clevis
5. Cap screw
6. Lock nut
Chassis