Grooming Reel Bearing Replacement - Toro 04384 Service Manual

Grooming Reel Bearing Replacement

4
3
2
1
13
14
12
1. Pivot hub
2. Spacer
3. Idler bracket
4. Spacer
5. Drive plate (cutting unit RH side)
6. O- -ring
NOTE: The groomer reel drive is located on the oppo-
site side of the cutting unit from the hydraulic cutting reel
motor.
Bearing Removal
1. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
2. Remove front roller, grooming reel and drive plate
assembly from right side of cutting unit (see Grooming
Reel Removal in this section).
Groomer
6
5
7
11
10
(toward center of
7. Retaining ring
8. Grease fitting
9. Bearing
10. Seal
11. Idler pulley
(toward center of
9
8
(toward center of
9
Seal lip
cutting unit)
Figure 11
3. Remove groomer support plate assembly from side
of cutting unit:
A. Remove two (2) socket head screws and lock
nuts that secure motor mount to cutting unit (Fig. 12).
Remove motor mount from cutting unit.
B. Remove lock nut and spring washer that secure
LH groomer arm lift rod to support plate (Fig. 13). Re-
move support plate from cutting unit.
Page 8 - - 12
Seal lip
cutting unit)
10
10
Seal lip
cutting unit)
12. Lock nut
13. Bearing
14. Retaining ring
15. Support plate (cutting unit LH side)
16. Plug
Greensmaster 3250--D
16
15
9