Toro 04384 Service Manual page 109

5. If hydraulic fittings are to be removed from reel mo-
tor, mark fitting orientation to allow correct assembly.
Remove hydraulic fittings and O--rings from motor. Dis-
card removed O--rings.
6. Inspect threads and sealing surfaces of fittings and
motor ports. Replace components if damage is found.
Installation (Figs. 50 and 51)
1. If fittings were removed from reel motor, lubricate
and place new O--rings onto fittings. Install fittings into
reel motor openings making sure that fitting orientation
is as noted during removal. Tighten fittings (see Hydrau-
lic Fitting Installation in the General Information section
of this chapter).
2. Coat spline shaft of the reel motor with No. 2 multi-
purpose lithium base grease.
3. Rotate the motor clockwise so the motor flanges
clear the cap screws in the cutting unit side plates. Align
reel motor shaft splines with cutting reel insert splines.
Slide motor shaft into reel insert.
CENTER REEL MOTOR
4
8
18
17
12
5
4
19
15
13
13
RIGHT
FRONT
1. Bulkhead lock nut
2. Bulkhead lock nut
3. Washer head screw
4. Hydraulic hose
5. Center reel motor
6. Bulkhead bracket
7. Hydraulic tube
8. Hydraulic hose
9. Washer
Greensmaster 3250--D
1
9
10
11
Figure 51
10. Spacer
11. Grommet
12. Hydraulic straight fitting
o
13. 90 hydraulic fitting
14. Hose bracket
15. O- -ring
16. Hydraulic hose
17. O- -ring
18. O- -ring
Page 4 - - 77
4. Rotate the motor counterclockwise until the motor
flanges are encircling the cap screws. Tighten two (2)
cap screws to secure reel motor to cutting unit.
5. Remove caps and plugs from disconnected hydrau-
lic hoses and motor fittings.
6. Using labels placed during reel motor removal, lubri-
cate new O--rings and connect hydraulic hoses to reel
motor. Tighten hose connections (see Hydraulic Hose
and Tube Installation in the General Information section
of this chapter).
7. Check oil level in hydraulic reservoir and add correct
oil if necessary.
8. Follow Hydraulic System Start--up procedures (see
Hydraulic System Start--up in this section).
1
9
27
2
21
6
3
20
22
26
16
7
9
19. O- -ring
20. Tube clamp
21. Cap screw
22. Lock nut
23. Hydraulic T- -fitting
24. Hose retainer
25. Lock nut
26. Hose retainer
27. Cable tie
10
11
3
25
14
9
23
24
3
Hydraulic System