Warning Light Cluster; Service And Repairs 5 - Toro 04384 Service Manual

Warning Light Cluster

Glow Plug Indicator Light
The glow plug indicator light should come on when the
ignition switch is placed in the RUN position prior to plac-
ing the ignition switch in START. The light should stay lit
for approximately six (6) seconds while the ignition
switch is left in the RUN position.
High Temperature Warning Light
If the engine coolant temperature reaches 220
o
(105 C) (approximate), the high temperature warning
light will come on and the engine will shut down.
To test the high temperature warning light and circuit wir-
ing, turn ignition switch to the RUN position and ground
the wire attached to high temperature warning switch lo-
cated on the engine water pump housing (see High
Temperature Warning Switch in this section). The high
temperature warning light should illuminate when the
wire is grounded.
Engine Oil Pressure Light
The engine oil pressure light should come on when the
ignition switch is in the RUN position with the engine not
running. Also, it should illuminate with the engine run-
ning if the engine oil pressure drops to an unsafe level.
IMPORTANT: If the oil pressure indicator light is il-
luminated with the engine running, shut off the en-
gine immediately.
To test the oil pressure light and circuit wiring, ground the
wire attached to oil pressure switch located on the en-
gine near the oil filter. Turn ignition switch to the RUN
position; the engine oil pressure light should come on in-
dicating correct operation of the indicator light and cir-
cuit wiring.
Charge Indicator Light
The charge indicator light should come on when the igni-
tion switch is in the RUN position with the engine not run-
ning. Also, it should illuminate with an improperly
operating charging circuit while the engine is running.
Testing Indicator Lights
1. Remove console cover from console assembly to
gain access to indicator lights (see Control Console Dis-
assembly in the Service and Repairs section of Chapter
7 -- Chassis).
2. Apply 12 VDC to terminals 1A and 2A (Fig. 11) and
ground terminals 1B and 2B (Fig. 11).
3. Both indicator lights should illuminate.
Greensmaster 3250--D
2
o
F
1
1. Glow plug indicator
2. High temperature
2
1
1B (--)
2B (--)
1. Glow plug indicator
2. High temperature
3. Engine oil pressure
Page 5 - - 13
3
4
Figure 10
3. Engine oil pressure
4. Charge indicator
5
6
1A (+)
2A (+)
Figure 11
4. Charge indicator
5. Indicator light front
6. Indicator light back
Electrical System
3
4