Special Tools; Special Tools - Toro 04384 Service Manual

Special Tools

Special tools for servicing Toro Commercial Products
are available from your Toro Distributor. Some of these
tools may have been supplied with your machine or are
available as Toro parts.
Gauge Bar Assembly
Use gauge bar to verify height--of--cut adjustment.
Toro Part Number: 108- -6715
Bedknife Screw Tool
This screwdriver--type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar.
IMPORTANT: To prevent damage to the bedbar, DO
NOT use an air or manual impact wrench with this
tool.
Toro Part Number: TOR510880
Handle Assembly
For applying lapping compound to cutting units while
keeping hands a safe distance from the rotating reel.
Toro Part Number: 29- -9100
Components for the handle assembly are available indi-
vidually as follows:
Brush 36--4310
Handle 29--9080
Handle cap 2410--18
DPA Cutting Units
Page 7 - - 4
Used for Height- -of- -
Cut adjustment
Figure 3
Figure 4
Figure 5
Greensmaster 3250--D