Toro 04384 Service Manual page 243

The groomer drive side plate assembly incorporates the
idler system for tensioning the groomer drive belt. The
idler system uses a spring to maintain proper belt ten-
sion.
Removal
1. Remove groomer belt cover, drive belt and drive
pulley from groomer drive side of mower (see Grooming
Reel Removal in this section).
2. Using Figures 15 and 16 as guides, remove idler
bracket, idler pulley and/or idler bearings as needed.
Installation
1. Assemble components using Figures 15 and 16 as
guides.
NOTE: When properly installed, the idler pulley should
move freely from side to side on the idler bracket pin.
2. Install drive pulley, drive belt and belt cover to right
side of mower (see Grooming Reel Installation in this
section).
3. Check and adjust grooming reel height and mower
height--of--cut settings.
Greensmaster 3250--D
5
1
1. Drive pulley
2. Idler pulley assembly
3. Driven pulley
Page 8 - - 15
2
4
3
Figure 16
4. Drive plate assembly
5. Groomer drive belt
Groomer