Cutting Reel Motors - Toro 04384 Service Manual

Cutting Reel Motors

FRONT REEL MOTORS
15
17
RIGHT
FRONT
1. Cap screw
2. Flat washer
3. Tube clamp
4. Lock nut
5. Plug
o
6. 90 Hydraulic fitting
7. Hydraulic fitting
8. Hydraulic fitting
9. O- -ring
10. Bulkhead nut
Removal (Figs. 50 and 51)
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove key from the ignition switch.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components.
Hydraulic System
29
14
7
30
7
29
6
30
10
8
13
14
15
Figure 50
11. Washer
12. Spacer
13. Reel motor
14. Hose assembly
15. Hose assembly
16. Hydraulic fitting
17. Hose assembly
18. T- -block
19. Cap screw
20. Hydraulic tube
Page 4 - - 76
20
5
9
18
16
19
11
24
26
17
12
7
11
27
6
28
13
28
8
27
21. Hydraulic tube
22. Hydraulic tube
23. Hydraulic tube
24. Rubber grommet
25. O- -ring
26. O- -ring
27. O- -ring
28. O- -ring
29. O- -ring
30. O- -ring
2. Label hydraulic hoses for assembly purposes.
3. Disconnect hydraulic hoses from fittings on the reel
motor. Allow hoses to drain into a suitable container.
Cap or plug hoses and motor fittings to prevent contami-
nation.
4. Loosen two (2) cap screws that secure the hydraulic
reel motor to the cutting unit side plate. Rotate motor
clockwise and remove motor from cutting unit.
NOTE: The position of hydraulic fittings on the reel mo-
tor is critical to properly connecting hydraulic hoses.
1
2
3
3
23
22
21
25
Greensmaster 3250--D
4