Toro 04384 Service Manual page 135

5. Remove cap screw and flat washer securing the con-
sole shroud to the hydraulic tank. Remove both cap
screws and flat washers securing the console shroud to
the lower panel (Fig. 73).
6. Remove three (3) washer head screws that secure
the mounting plate (item 29) to the frame. Two screws
are located on the top of the plate at the front corners of
the hydraulic tank. The third screw is in front of the castor
fork and below the plate.
7. Tilt mounting plate assembly up by lifting at the rear
of the machine. Prop up plate securely. Remove four (4)
cap screws (item 16), flat washers (item 12) and grom-
mets (item 13) securing the hydraulic tank to the mount-
ing plate.
8. Remove hydraulic tank from the mounting plate.
Inspecting Reservoir Parts (Fig. 70)
1. Clean tank and filler screen with solvent.
2. Inspect tank for leaks, cracks or other damage.
3. Replace hydraulic hoses if worn or leaking.
Installing Hydraulic Reservoir (Fig. 70)
1. Place antiseize lubricant into all four (4) inserts at the
bottom of the hydraulic tank. Position tank onto the
mounting plate.
2. Secure hydraulic tank to the mounting plate with four
(4) cap screws (item 16), flat washers (item 12) and
grommets (item 13). Torque cap screws from 30 to 60
in- -lb (3.4 to 6.8 N- -m).
3. Secure mounting plate to the frame with three (3)
washer head screws. Two screws go on the top of the
plate at the front corners of the fuel tank. The third screw
goes in front of the castor fork and below the plate.
4. Secure console shroud to the hydraulic tank with cap
screw and flat washer and to the lower panel with both
cap screws and flat washers (Fig. 73).
5. Secure return hose (item 21) to hydraulic barb fitting
(item 9) with hose clamp.
6. Secure pump inlet hose to gear pump with hose
clamp (Fig. 71).
7. Connect hose assembly to the hydraulic fitting
welded to the reel motor case drain tube located below
the right side of the frame (Fig. 72).
8. Fill hydraulic tank with new hydraulic oil.
9. Follow Hydraulic System Start--up procedures (see
Hydraulic System Start--up in this section).
Greensmaster 3250--D
PUMP INLET HOSE
1. Hose assembly
4
3
2
1. Cap screw
2. Cap screw
3. Flat washer
Page 4 - - 103
Figure 71
1
WELDED
FITTING
2
Figure 72
2. Case drain tube
1
3
6
Figure 73
4. Console shroud
5. Hydraulic tank
6. Lower panel
Hydraulic System
5