Toro 04384 Service Manual page 193

Disassembly
1. Park machine on a level surface. Make sure engine
is off and parking brake is engaged.
2. Remove center cutting unit from lift arm.
3. Disassemble center lift arm as needed using Figures
13 and 14 as guides.
Assembly
1. If lift frame (item 25 in Fig. 13) was removed from ma-
chine:
A. Adjust eccentric bushings (item 22 in Fig. 13) as
needed so that lift frame is level when the lift frame is
in the raised position.
B. Install thrust washers (item 12 in Fig. 13) as need-
ed so that lift frame is centered between the front
wheel mounts when the lift frame is in the raised posi-
tion.
2. Assemble center lift arm using Figures 13 and 14 as
guides.
A. If clevis (item 31 in Fig. 13) was removed from
center lift frame, torque cap screw from 67 to 83 ft- -lb
(91 to 112 N- -m).
B. If pull frame (item 1 in Fig. 14) was removed from
clevis on lift frame, torque cap screw from 67 to 83
ft- -lb (91 to 112 N- -m).
3. Attach cutting unit to lift arm.
4. Check that when raised to the transport position, the
cutting unit is secured by the transport plate. If neces-
sary, loosen two (2) cap screws (item 30 in Fig. 13) and
reposition transport plate.
Greensmaster 3250--D
2
1
3
1. Pull frame
2. Pivot spacer
3. Bushing
Page 6 - - 17
67 to 83 ft- -lb
5
(91 to 112 N- -m)
4
3
6
Figure 14
4. Clevis
5. Cap screw
6. Lock nut
Chassis