Reel Motor Service - Toro 04384 Service Manual

Reel Motor Service

5
11
3
12
4
1. Rear cover
2. Drive gear
3. Seal
4. Tab washer
Disassembly
1. Plug motor ports and clean the outside of the motor
thoroughly. After cleaning, remove plugs and drain any
oil out of the motor.
2. Use a marker or scribe to make a diagonal mark
across the front flange, body and rear cover for reas-
sembly purposes (Fig. 53).
IMPORTANT: Avoid using excessive clamping
pressure on the motor flange to prevent distorting
the casting.
3. Clamp mounting flange of motor in a vise with the
shaft end down.
4. Loosen cap screws on the rear cover.
5. Take motor from the vise and remove cap screws.
6. Remove front flange from the body, then remove rear
cover. Locate and remove dowel pins from body.
Hydraulic System
9
8
7
6
2
Figure 52
5. Pressure seal
6. Back- -up ring
7. O- -ring
8. Body
Page 4 - - 78
5
6
7
9. Idler gear
10. Cap screw (4 used)
11. Front flange
12. Washer (if equipped)
DIAGONAL MARK
10
1
215 to 280 in- -lb
(24 to 32 N- -m)
Figure 53
Greensmaster 3250--D