Snmp Workflow - Cisco 220 Series Smart Plus Administration Manual

SNMP
SNMP Versions and Workflow
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x

SNMP Workflow

SNMP Workflow
For security reasons, SNMP is disabled by default. Before you can manage the
switch via SNMP, you must enable the SNMP service on the switch as described in
the Configuring TCP/UDP Services
The following is the recommended series of actions for configuring SNMP:
If you decide to use SNMP v1 or v2:
If desired, define SNMP view(s) on the SNMP > Views page, as described in the
Configuring SNMP Views
Define SNMP group(s) on the SNMP > Groups page, as described in the
Configuring SNMP Groups
specified SNMP view.
Define an SNMP community on the SNMP > Community page, as described in the
Configuring SNMP Communities
with access rights and view in Basic mode or with a group in Advanced mode.
• Basic mode—The access rights of a community can configure with Read
Only or Read Write. In addition, you can restrict the access to the community
to only certain MIB objects by selecting a view (defined on the SNMP >
Views page).
• Advanced Mode—The access rights of a community are defined by a group
(defined on the SNMP > Groups page). You can configure the group with a
specific security model. The access rights of a group are Read, Write, and
Notify.
Define the notification recipient(s) on the SNMP > Notification Recipients
SNMPv1,2 page, as described in the
Recipients section.
section.
section.
section. The group can be associated with the
section. The community can be associated
Configuring SNMPv1,2 Notification
19
266