Workflow To Configure Qos Settings - Cisco 220 Series Smart Plus Administration Manual

Quality of Service

Workflow to Configure QoS Settings

Workflow to Configure QoS Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
• All other user configurations remain intact.
To configure the QoS parameters, perform the following:
Choose the QoS mode (basic, advanced, or disabled) for the switch, and assign
each interface a default CoS priority as described in the
Properties section.
Assign the schedule method (Strict Priority or WRR) and bandwidth allocation for
WRR to the egress queues as described in the
Designate an egress queue to each CoS/802. 1 p priority as described in the
Mapping CoS/802.1p to a Queue
mode, all incoming packets will be put into the designated egress queues
according to the CoS/802. 1 p priority in the packets.
Designate an egress queue to each IP precedence as described in the
IP Precedence to Queue
Designate an egress queue to each IP DSCP/TC value on the DSCP to Queue
page, as described in the
DSCP trusted mode, incoming packets are put into the egress queues based on
the their DSCP/TC value.
Remark the CoS/802. 1 p priority, IP precedence, and/or DSCP value for egress
traffic on a port. The CoS/802/1p priority and IP precendence, or the DSCP value
and IP precendence can be remarked simultaneously, but the CoS/802/1p priority
and DSCP value cannot be remarked simultaneously.
• Remark the CoS/802. 1 p priority for egress traffic from each queue as
descirbed in the
• Remark the IP precedence for egress traffic from each queue as descirbed
in the Mapping Queues to IP Precedences
• Remark the DSCP value for egress traffic from each queue as descirbed in
the Mapping Queue to DSCP
Enter bandwidth and rate limits:
• Set ingress rate limit and egress shaping rate per port as descirbed in the
Configuring Bandwidth
section. If the switch is in CoS/802. 1 trusted
section.
Mapping DSCP to Queue
Mapping Queues to CoS/802.1p
section.
section.
Configuring QoS
Configuring QoS Queues
section. If the switch is in
section.
section.
18
section.
Mapping
241