Table of Contents
Advertisement
Administration: System Logs
Configuring Remote Logging Settings
Configuring Remote Logging Settings
STEP 1
STEP 2
STEP 3
STEP 4
Viewing Memory Logs
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
Use the Remote Log Servers page to define the remote SYSLOG servers where
log messages are sent (using the SYSLOG protocol). For each server, you can
configure the severity of the messages that it receives.
To configure a remote SYSLOG server:
Click Administration > System Log > Remote Log Servers.
Click Add to add a remote SYSLOG server.
Enter the following information:
•
Server Definition—Select whether to identify the remote log server by IP
address or name.
•
IP Version—Select either Version 4 or Version 6 if the remote log server is
identified by IP address.
•
Log Server IP Address/Name—Enter the IP address or hostname of the
remote log server.
•
UDP Port—Enter the UDP port to which the log messages are sent.
•
Facility—Select a facility from which system logs are sent to the remote
server. Only one facility can be assigned to a server.
•
Minimum Severity—Select the minimum level of system log messages to
be sent to the server.
Click Apply. The remote SYSLOG server is added, and the Running Configuration
is updated.
The switch can write to the following logs:
•
Log in RAM (cleared during reboot). See
more information.
•
Log in flash memory (cleared only upon user command). See
Memory Logs
for more information.
Viewing RAM Memory Logs
Viewing Flash
3
for
36
Advertisement
Table of Contents
