Mapping Queues To Cos/802.1P - Cisco 220 Series Smart Plus Administration Manual

Quality of Service
Workflow to Configure QoS Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
To map DSCP to queues:
Click Quality of Service > General > DSCP to Queue.
The Ingress DSCP column displays the DSCP value in the incoming packet and its
associated class.
Select the traffic forwarding queue from the Output Queue drop-down menu to
which the DSCP value is mapped.
Click Apply. DSCP values to queues are mapped, and the Running Configuration is
updated.
Click Restore Defaults to restore the DSCP to Queue mappings to their factory
default settings.

Mapping Queues to CoS/802.1p

Use the Queues to CoS/802. 1 p page to remark the CoS/802. 1 p priority for egress
traffic from each queue.
To map queues to CoS values:
Click Quality of Service > General > Queues to CoS/802.1p.
For each output queue select the CoS/802. 1 p priority to which egress traffic from
the queue is remarked.
Click Apply. The Running Configuration is updated.
Click Restore Defaults to restore the Queue to CoS/802. 1 p mappings to their
factory default settings.
Mapping Queues to IP Precedences
To map egress queues to IP precedences:
Click Quality of Service > General > Queues to IP Precedence.
For each output queue select the IP precedence to which egress traffic from the
queue is remarked.
18
247