Configuring Multicast Filtering; Configuring Multicast Filter Profiles - Cisco 220 Series Smart Plus Administration Manual

Multicast Forwarding

Configuring Multicast Filtering

STEP 5
Configuring Multicast Filtering
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
• MLD Maximum Multicast Group—Enter the maximum number of MLD
groups that are allowed on the interface.
• MLD Exceed Action—Denies or replaces the existing group with the new
group for which the IGMP report was recevied when the limit is reached.
Click Apply. The Running Configuration is updated.
You can add a Multicast filter profile to permit or deny a range of Multicast groups
be learned when the join groups match the profile IP group range, and assign the
profile to an interface. The Multicast filter settings will be applied to the selected
interface.
This section includes the following topics:
•

Configuring Multicast Filter Profiles

• Configuring Interface Filter Settings
Configuring Multicast Filter Profiles
A Multicast filter profile permits or denies a range of Multicast groups to be
learned when the join group matches the filter profile IP group range.
To create a Multicast filter profile:
Click Multicast > Multicast Filtering > Profiles.
Select either IPv4 or IPv6 that the filter profile is applied to IPv4 or IPv6 Multicast
traffic, and click Go.
Click Add to create a profile.
Enter the following information:
• Profile Index—Enter the sequence number for the profile.
• IP Version—Select ether Version 4 or Version 6 to apply the filter profile to
IPv4 or IPv6 Multicast traffic.
• Start Multicast Address—Enter the starting Multicast group address.
14
170