Configuring Error Recovery Settings - Cisco 220 Series Smart Plus Administration Manual

Port Management

Configuring Error Recovery Settings

Configuring Error Recovery Settings
STEP 1
STEP 2
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
Use the Error Recovery Settings page to globally set the automatic recovery
interval, and disable or enable the error-disabled port to recover from specific
causes. You can also manually reactivate the suspended ports.
To configure error recovery settings:
Click Port Management > Error Recovery Settings.
Enter the following global port settings:
• Automatic Recovery Interval—Enter the time in seconds to recover from
the specified error-disabled state. The range is 0 to 86400 seconds. The
same interval is applied to all causes. The default interval is 300 seconds.
• Automatic ErrDisable Recovery—Enables the error-disabled port to
recover from specific causes. The available causes are:
ACL
- —Check Enable to enable the timer to recover from the ACL causes.
ARP Inspection
-
ARP detection causes.
BPDU Guard
-
BPDU Guard cause.
- Broadcast Flood
broadcast flood cause.
DHCP Rate Limit
-
DHCP rate limit causes.
PoE
- —(Only applicable for PoE models) Check Enable to enable the timer
to recover from the Power over Ethernet (PoE) causes.
Port Security
-
security causes.
Self Loop
- —Check Enable to enable the timer to recover from the
selfloop cause.
- Unicast Flood
unicast flood causes.
Unknown Multicast Flood
-
from the unknown multicast flood causes.
—Check Enable to enable the timer to recover from the
—Check Enable to enable the timer to recover from the
—Check Enable to enable the timer to recover from the
—Check Enable to enable the timer to recover from the
—Check Enable to enable the timer to recover from the port
—Check Enable to enable the timer to recover from the
—Check Enable to enable the timer to recover
9
104