Ipv4 Management And Interface - Cisco 220 Series Smart Plus Administration Manual

IP Configuration

IPv4 Management and Interface

IPv4 Management and Interface
STEP 1
STEP 2
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
To manage the switch by using the web-based interface, the IPv4 management IP
address must be defined and known. The switch IP address can be manually
configured or automatically taken from a DHCP server.
To configure the IPv4 management IP address:
Click Administration > Management Interface > IPv4 Interface.
Enter the following information:
• Management VLAN—Select the management VLAN used to access the
switch through Telnet or the web-based interface. VLAN1 is the default
management VLAN.
• IP Address Type—Select one of the following options:
- Dynamic—Discovers the IP address using DHCP from the management
VLAN.
- Static—Manually defines a static IP address.
If a static IP address is used, enter the following fields:
• IP Address—Enter the management IP address of the switch. The default is
192. 1 68. 1 .254.
• Mask—Enter the IP address mask or prefix length.
Network Mask
-
Prefix Length
-
• Administrative Default Gateway—Select User Defined to manually enter
the default gateway IP address, or select None to remove the selected
default gateway IP address from the interface.
• Operational Default Gateway—Displays the current default gateway IP
address.
If the switch is not configured with a default gateway, it cannot
NOTE
communicate with other devices that are not in the same IP subnet.
—Select and enter the IP address mask.
—Select and enter the length of the IPv4 address prefix.
15
174