Table of Contents
Advertisement
Administration: Time Settings
Configuring SNTP Server
STEP 6
Configuring SNTP Server
STEP 1
STEP 2
STEP 3
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
-
Week—Week within the month from which DST begins every year.
-
Month—Month of the year in which DST begins every year.
-
Time—The time at which DST begins every year.
•
To—Enter the date when DST ends each year.
-
Day—Day of the week on which DST ends every year.
-
Week—Week within the month from which DST ends every year.
-
Month—Month of the year in which DST ends every year.
-
Time—The time at which DST ends every year.
Click Apply. The system time is defined, and the Running Configuration is updated.
The switch can be configured to synchronize its system clock with an SNTP server
specified on the SNTP Settings page.
To specify an SNTP server by name, you must first configure DNS server(s) on the
switch and enable Main Clock Source (SNTP Servers) on the System Time page.
To add an SNTP server:
Click Administration > Time Settings > SNTP Settings.
Enter the following information:
•
Host Definition—Select whether to specify the SNTP server by IPv4
address or by host name.
•
SNTP Server IP Address/Name—Enter the IPv4 address or hostname of
the SNTP server.
•
SNTP Server Port—Enter the UDP port number to be specified in the SNTP
message headers. By default, the port number is the well-known IANA value
of 123.
Click Apply. The SNTP server is added, and the Running Configuration is updated.
6
68
Advertisement
Table of Contents
