Configuring Port To Vlan - Cisco 220 Series Smart Plus Administration Manual

Managing VLANs

Configuring Port to VLAN

STEP 5
Configuring Port to VLAN
STEP 1
STEP 2
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
• Frame Type—Select the type of frame that the interface can receive.
Frames that are not of the configured frame type are discarded at ingress.
These frame types are only available in General mode. Possible values are:
- Admit All—The interface accepts all types of frames: untagged frames,
tagged frames, and priority tagged frames.
- Admit Tagged Only—The interface accepts only tagged frames.
- Admit Untagged Only—The interface accepts only untagged and
priority frames.
• Ingress Filtering—(Available only in General mode) Check Enable to enable
ingress filtering. When an interface is ingress filtering enabled, the interface
discards all incoming frames that are classified as VLANs of which the
interface is not a member. Ingress filtering can be disabled or enabled on
general ports. It is always enabled on access ports and trunk ports.
• Uplink—(Available only in Trunk mode) Check Enable to set the interface as
an uplink port.
• TPID—If Unlink is enabled, select the Modified Tag Protocol Identifier (TPID)
value for the interface.
Click Apply. The interface's VLAN settings are defined, and the Running
Configuration is updated.
Use the Port to VLAN page to configure the port members of a VLAN.
To map ports or LAGs to a VLAN:
Click VLAN Management > Port to VLAN.
Select a VLAN and the interface type (Port or LAG), and click Go.
11
128