Table of Contents
Advertisement
Multicast Forwarding
Configuring MLD Snooping
STEP 3
STEP 4
STEP 5
STEP 6
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
•
Report Suppression—Check Enable to enable IGMP Snooping report
suppression, or uncheck to disable this feature and forward all MLDv1
reports to Multicast routers.
Click Apply. The Running Configuration is updated.
Select a VLAN, and click Edit.
Enter the following information:
•
VLAN ID—Select the VLAN ID.
•
MLD Snooping Status—Enable or disable MLD Snooping on the VLAN. The
switch monitors network traffic to determine which hosts have asked to be
sent Multicast traffic. The switch performs MLD Snooping only when MLD
Snooping is enabled globally and on the VLAN.
•
MRouter Ports Auto Learn—Enable or disable Auto Learn for the Multicast
router.
•
Query Robustness—Enter the Robustness Variable value to be used if the
switch cannot read this value from messages sent by the elected querier.
•
Query Interval—Enter the query interval value to be used by the switch if
the switch cannot derive the value from the messages sent by the elected
querier.
•
Query Max Response Interval—Enter the query maximum response delay
to be used if the switch cannot read the maximum response time value from
general queries sent by the elected querier.
•
Last Member Query Counter—Enter the last member query count to be
used if the switch cannot derive the value from the messages sent by the
elected querier.
•
Last Member Query Interval—Enter the maximum response delay to be
used if the switch cannot read maximum response time value from group-
specific queries sent by the elected querier.
•
Immediate Leave—When enabled, reduces the time it takes to block
unnecessary MLD traffic sent to a switch port.
Click Apply. The Running Configuration is updated.
14
166
Advertisement
Table of Contents
