Cisco 220 Series Smart Plus Administration Manual page 193

Configuring Security
Configuring Management Access Methods
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
HTTP
- —Assigns HTTP access to the rule. Users requesting access to the
switch who meet the HTTP access profile criteria, are permitted or
denied.
Secure HTTP (HTTPS)
-
meet the HTTPS access profile criteria, are permitted or denied.
SNMP
- —Users requesting access to the switch who meet the SNMP
access profile criteria are permitted or denied.
• Action—Select Permit to permit the users that attempt to access the switch
by using the configured access method from the interface and IP source
defined in this rule, or select Deny to deny access.
• Applies to Interface—Select the interface attached to the rule. The options
are:
- All—Applies to all interfaces.
- User Defined—Applies only to a specific port or LAG. You need to select
a port or LAG from the Interface field.
• Interface—Select the type of interface and specific itnerface if
Defined
is selected.
• Applies to Source IP Address—Select the type of source IP address to
which the access profile applies. Select one of the following values:
- All—Applies to all types of IP addresses.
- User Defined—Applies to only those types of IP addresses defined in
the fields.
• IP Version—Select either Version 4 or Version 6 to define the source IP
address.
• IP Address—Enter the source IP address.
• Mask—Select the format for the subnet mask for the source IP address, and
enter a value in one of the field:
Network Mask
-
belongs and enter the subnet mask in dotted decimal format.
- Prefix Length —Select the Prefix Length and enter the number of bits that
comprise the source IP address prefix.
—Users requesting access to the switch who
—Select the subnet to which the source IP address
16
User
191