Table of Contents
Advertisement
Configuring Security
Configuring Users
Configuring Users
NOTE
STEP 1
STEP 2
STEP 3
Cisco 220 Series Smart Plus Switches Administration Guide Release 1.0.0.x
The default username/password is cisco/cisco. The first time that you log in with
the default username and password or when the current password expires, you
are required to set a new password. Password complexity is enabled by default.
Use the User Accounts page to add additional users that are permitted to manage
the switch or to change the passwords of existing users.
It is not permitted to delete all users. If all users are selected, the Delete button is
disabled.
To add a new user:
Click Administration > User Accounts.
The User Account Table displays all users defined on the switch and their privilege
levels.
Click Add to add a new user or click Edit to modify a user.
Enter the following information:
•
User Name—Enter a new username between 0 and 32 alphanumeric
characters.
•
Password—Enter a password. The password must comply with the
mininum strength and complexity requirements shown on the page.
•
Confirm Password—Enter the password again.
•
Password Strength Meter—Displays the strength of password. The rules
for password strength and complexity are configured on the Password
Strength page. See the
for more details.
•
User Level—Select the privilege level for the user.
-
Read-Only CLI Access (1)
interface (CLI) and perform the commands that do not change the switch
configuration. User cannot access the web-based interface.
-
Read/Write Management Access (15)
interface, and can configure the switch.
Configuring Password Complexity Rules
—User can only access the command-line
—User can access the web-based
16
section
181
Advertisement
Table of Contents
