Load-Balance Policy - Draytek Vigor2830 Series User Manual
Vigor2830 series adsl2+ security firewall
Hide thumbs
Also See for Vigor2830 Series:
- Quick start manual (48 pages) ,
- User manual (399 pages) ,
- User manual (472 pages)
Table of Contents
Advertisement
4
.
1
.
5
L
o
a
d
-
B
a
l
a
n
4
.
1
.
5
L
o
a
d
-
B
a
l
a
n
This router supports the function of load balancing. It can assign traffic with protocol type, IP
address for specific host, a subnet of hosts, and port range to be allocated in WAN1, WAN2,
and WAN3 interface. The user can assign traffic category and force it to go to dedicate
network interface based on the following web page setup. Twenty policies of load-balance are
supported by this router.
Note: Load-Balance Policy is running only when WAN1, WAN2 and WAN3 are
activated.
Index
Enable
Protocol
WAN
Src IP Start
Src IP End
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End
Move UP/Move Down
Click Index 1 to access into the following page for configuring load-balance policy.
c
e
P
o
l
i
c
y
c
e
P
o
l
i
c
y
Click the number of index to access into the load-balance policy
configuration web page.
Check this box to enable this policy.
Use the drop-down menu to change the protocol for the WAN
interface.
Use the drop-down menu to change the WAN interface.
Displays the IP address for the start of the source IP.
Displays the IP address for the end of the source IP.
Displays the IP address for the start of the destination IP.
Displays the IP address for the end of the destination IP.
Displays the IP address for the start of the destination port.
Displays the IP address for the end of the destination port.
Use Up or Down link to move the order of the policy.
119
Vigor2830 Series User's Guide
Advertisement
Table of Contents
