For Vigor2830Vn - Draytek Vigor2830 Series User Manual

1 . 2 . 3 F o r V i g o
1 . 2 . 3 F o r V i g o
LED
ACT (Activity)
USB
CSM
WLAN
DSL
WAN2
Line
Phone 1/2
LED on Connector
GigaLAN 1/2/3/4
WAN2 (Giga)
Vigor2830 Series User's Guide
r 2 8 3 0 V n
r 2 8 3 0 V n
Left LED
(Green)
Right LED
(Green)
Left LED
(Green)
Right LED
(Green)
Status Explanation
Blinking The router is powered on and running normally.
Off The router is powered off.
On USB device is connected and ready for use.
Blinking The data is transmitting.
On The profile(s) of CSM (Content Security
Management) for IM/P2P, URL/Web Content Filter
application can be enabled from Firewall
>>General Setup. (Such profile must be
established under CSM menu).
On
Wireless access point is ready.
Blinking
It will blink slowly while wireless traffic goes
through.
If ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and it will
return to normal condition after two minutes. (You
need to setup WPS within 2 minutes.)
On The router is ready to access Internet through DSL
link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is tranning.
On The WAN2 connection is ready.
Blinking It will blink while transmitting data.
On A PSTN phone call comes (in and out). However,
when the phone call is disconnected, the LED will
be off.
Off There is no PSTN phone call.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
Blinking A phone call comes.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps when left
LED is on.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps when left
LED is on.
6