Draytek Vigor2830 Series User Manual page 55

PPPoE Pass-through
WAN Connection
Detection
ISP Access Setup
IP Address From ISP
VCI - Type in the value provided by ISP.
Encapsulating Type - Drop down the list to choose the type
provided by ISP.
Protocol - Drop down the list to choose the one provided by
ISP.If you have already used Quick Start Wizard to set the
protocol, then it is not necessary for you to change any settings
in this group.
Modulation – Drop down the list to choose a proper
modulation for the router.
The router offers PPPoE dial-up connection. Besides, you also
can establish the PPPoE connection directly from local clients
to your ISP via the Vigor router. When PPPoA protocol is
selected, the PPPoE package transmitted by PC will be
transformed into PPPoA package and sent to WAN server.
Thus, the PC can access Internet through such direction.
For Wired LAN – If you check this box, PCs on the same
network can use another set of PPPoE session (different with
the Host PC) to access into Internet.
For Wireless LAN – If you check this box, PCs on the same
wireless network can use another set of PPPoE session
(different with the Host PC) to access into Internet.
Such function allows you to verify whether network connection
is alive or not through ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection.
Ping IP – If you choose Ping Detect as detection mode, you
have to type IP address in this field for pinging.
TTL (Time to Live) – Displays value for your reference. TTL
value is set by telnet command.
Enter your allocated username, password and authentication
parameters according to the information provided by your ISP.
If you want to connect to Internet all the time, you can check
Always On.
Username – Type in the username provided by ISP in this
field.
Password – Type in the password provided by ISP in this field.
PPP Authentication – Select PAP only or PAP or CHAP for
PPP.
Idle Timeout – Set the timeout for breaking down the Internet
after passing through the time without any action. This setting
is active only when the Active on demand option for Active
Mode is selected in WAN>> General Setup page.
Usually ISP dynamically assigns IP address to you each time
you connect to it and request. In some case, your ISP provides
service to always assign you the same IP address whenever you
request. In this case, you can fill in this IP address in the Fixed
IP field. Please contact your ISP before you want to use this
function.
43
Vigor2830 Series User's Guide