Load-Balance Policy - Draytek Vigor2950 Series User Manual
Dual-wan ssl vpn appliance
Hide thumbs
Also See for Vigor2950 Series:
- User manual (217 pages) ,
- Quick start manual (28 pages) ,
- User manual (221 pages)
Table of Contents
Advertisement
3
.
1
.
4
L
o
a
d
-
B
3
.
1
.
4
L
o
a
d
-
B
This router supports the function of load balancing. It can assign traffic with protocol type,
IP address for specific host, a subnet of hosts, and port range to be allocated in WAN1 or
WAN2 interface. The user can assign traffic category and force it to go to dedicate network
interface based on the following web page setup. Twenty policies of load-balance are
supported by this router.
Note: Load-Balance Policy is running only when both WAN1 and WAN2 are
activated.
Index
Enable
Protocol
WAN
Src IP Start
Src IP End
Dest IP Start
Dest IP End
Dest Port Start
30
IP Address – Type the IP address.
Subnet Mask – Type the subnet mask.
a
l
a
n
c
e
P
o
l
i
c
y
a
l
a
n
c
e
P
o
l
i
c
y
Click the number of index to access into the load-balance policy
configuration web page.
Check this box to enable this policy.
Use the drop-down menu to change the protocol for the WAN
interface.
Use the drop-down menu to change the WAN interface.
Display the IP address for the start of the source IP.
Display the IP address for the end of the source IP.
Display the IP address for the start of the destination IP.
Display the IP address for the end of the destination IP.
Display the IP address for the start of the destination port.
Vigor2950 Series User's Guide
Advertisement
Table of Contents
