Load-Balance Policy - Draytek Vigor 2820 User Manual
Vigor2820 series adsl2/2+ security firewall
Hide thumbs
Also See for Vigor 2820:
- Quick start manual (41 pages) ,
- Declaration of conformity (1 page) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Enable
P1 to P4
Service Type
Add Tag
Click Clear to remove all the configurations in this page if you do not satisfy it. When you
finish the configuration, please click OK to save and exit this page. Or click Cancel to abort
the configuration and exit this page.
3
.
1
.
6
L
o
a
d
-
B
3
.
1
.
6
L
o
a
d
-
B
This router supports the function of load balancing. It can assign traffic with protocol type,
IP address for specific host, a subnet of hosts, and port range to be allocated in WAN1 or
WAN2 interface. The user can assign traffic category and force it to go to dedicate network
interface based on the following web page setup. Twenty policies of load-balance are
supported by this router.
Note: Load-Balance Policy is running only when both WAN1 and WAN2 are activated.
Vigor2820 Series User's Guide
Check this box to enable that channel. Only channel 3 to 8 can be
set in this page, for channel 1 to 4 are reserved for NAT using.
It means the LAN port 1 to 4. Check the box to designate the LAN
port for channel 3 to 8.
Normally, service type is used for the service of video stream (e.g.,
IPTV). It can divide the packets from remote control and from
video stream into different PVC. In general, the protocol used by
remote control is IGMP.
Normal – It means that the PVC can accept all packets except
IGMP.
IGMP – It means that the PVC can accept packets of IGMP only.
To identify the usage of PVC, check this box to invoke this setting.
And type the number for VLAN ID (number).
a
l
a
n
c
e
P
o
l
i
c
y
a
l
a
n
c
e
P
o
l
i
c
y
47
Hide quick links:
Advertisement
Table of Contents
