Serial Commands; Serial Baudrate - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Serial Commands

This section describes the following SFTOS system management commands pertaining to console port
connections (serial connections, EIA-232):
•
•
•
•
lineconfig
This command accesses the Line Config mode from the Global Config mode.
lineconfig
Syntax
Mode
Global Config
Usage
Users executing this command enter the Line Config mode.
Information
For details on modes, see
Example Figure 5-23. lineconfig Command Example
(S50) #configure
(S50) (Config)#lineconfig
(S50) (Line)#
Related
configure
Commands

serial baudrate

This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200}
Syntax
The no serial baudrate command sets the communication rate of the terminal interface to the 9600
default.
Default
9600
Mode Line Config
lineconfig on page 75
serial baudrate on page 75
serial timeout on page 76
show serial on page 76
Chapter 4, "Using the Command Line Interface," on page
Accesses the Global Config mode, which is the mode in which you can execute this
lineconfig
command.
23.
System Management Commands | 75