Garp Commands - Dell Force10 S2410-01-10GE-24P Command Reference Manual

GARP Commands

This chapter provides a detailed explanation of the General Attribute Registration Protocol (GARP)
commands, including GVRP and GMRP commands. The commands are divided into two functional
groups:
•
•
The sections in this chapter are:
•
•
•
GARP Commands
The commands in this sections are:
•
•
•
•
set garp timer join
This command sets the GVRP join time per port and per GARP. Join time is the interval between the
transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for a
VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds).
the value 20 centiseconds is 0.2 seconds.
nECu: sduCa,EsuTeaou
Syntax
oeunECu: sduCa,EsuTeaou
Show commands display switch settings, statistics, and other information.
Configuration commands configure features and options of the switch. For every configuration
command, there is a show command that displays the configuration setting.
Note:
The GARP and GVRP features were available in SFTOS before version 2.5.1, but the
commands were not tested in either 2.5.1 or 2.5.2, so the commands in this chapter are not
supported.
GARP Commands on page 251
GARP VLAN Registration Protocol (GVRP) Commands on page 254
GARP Multicast Registration Protocol (GMRP) Commands on page 257
set garp timer join on page 251
set garp timer leave on page 252
set garp timer leaveall on page 253
show garp on page 253
10-100
15
GARP Commands | 251