Show Telnet - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Default 1 (minute)
Mode
Line Config

show telnet

This command displays the current outbound telnet settings.
show telnet
Syntax
Modes Privileged Exec and User Exec
Outbound Telnet Login Timeout (in minutes)—Indicates the number of minutes an outbound telnet
session is allowed to remain inactive before being logged off. A value of 0, which is the default, results in
no timeout.
Maximum Number of Outbound Telnet Sessions—Indicates the number of simultaneous outbound
telnet connections allowed.
Allow New Outbound Telnet Sessions—Indicates whether outbound telnet sessions will be allowed.
telnet
This command establishes a new outbound Telnet connection to a remote host. The host value must be
a valid IP address. Valid values for port should be a valid decimal integer in the range of 0 to 65535,
where the default value is 23. If [debug] is used, the current telnet options enabled is displayed. The
optional line parameter sets the outbound telnet operational mode as 'linemode', where by default, the
operational mode is 'character mode'. The noecho option disables local echo.
telnet host [port] [debug] [line] [noecho]
Syntax
Modes
Privileged Exec and User Exec
telnetcon timeout
Command
Version 2.3
History
telnetcon maxsessions
Command
Version 2.3
History
remotecon maxsessions
This command specifies the maximum number of remote connection sessions that can be established.
A value of 0 indicates that no remote connection can be established. The range is 0 to 5.
Modified: Changed to ip telnet
Modified: Changed to ip telnet maxsessions
timeout.
System Management Commands | 73