Show Ip Brief - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Related
description
Commands
routing
ip address (routed)

show ip brief

This command displays all the summary information of the IP. This command takes no options.
nieAuadursaEt
Syntax
Mode Privileged EXEC and User EXEC
Default Time to Live—The computed TTL (Time to Live) of forwarding a packet from the local router to
the final destination.
Router ID—Is a 32 bit integer in dotted decimal format identifying the router, about which information is
displayed. This is a configured value.
Routing Mode—Shows whether the routing mode is enabled or disabled.
IP Forwarding Mode—Shows whether forwarding of IP frames is enabled or disabled. This is a
configured value.
show ip interface
This command displays all pertinent information about the IP interface.
show ip interfacerunit/slot/port
Syntax
Mode Privileged EXEC and User EXEC
IP Address—Is an IP address representing the subnet configuration of the router interface. This value
was configured into the unit.
Subnet Mask—Is a mask of the network and host portion of the IP address for the router interface. This
value was configured into the unit.
Active State—Displays whether the interface is active or inactive. An interface is
considered active if its link is up and in forwarding state.
Link Speed Data Rate—Is an integer representing the physical link data rate of the
specified interface. This is measured in megabits per second (Mbps).
MAC Address—Is the burned-in physical address of the specified interface. The format
is six two-digit hexadecimal numbers separated by colons.
Encapsulation Type—Is the encapsulation type for the specified interface. The types are
Ethernet or SNAP.
IP MTU—Displays the maximum transmission unit (MTU) size of a frame, in bytes.
Provide a description of the selected interface.
Enables routing for the selected interface
Configures an IP address on a routed interface
Routing Commands | 403