Dot1X Login; Dot1X Max-Req; Dot1X Port-Control - Dell Force10 S2410-01-10GE-24P Command Reference Manual

dot1x login

Syntax
Mode

dot1x max-req

Syntax
Default
Mode
Command
History
Related
Commands

dot1x port-control

Syntax
Default
| Security Commands
190
This command assigns the specified authentication login list to the specified user for 802.1x port
security. The user parameter must be a configured user and the listname parameter must be a
configured authentication login list.
dot1x login
user listname
Global Config
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.
dot1x max-req
count
The count value must be in the range 1 - 10.
The no version of this command sets the maximum number of times the authenticator state machine on
this port will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.
2
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Version 2.3
interface range
This command sets the authentication mode to be used on the specified port. The control mode may be
one of the following.
Force-unauthorized—The authenticator PAE unconditionally sets the controlled port to unauthorized.
Force-authorized—The authenticator PAE unconditionally sets the controlled port to authorized.
Auto—The authenticator PAE sets the controlled port mode to reflect the outcome of the authentication
exchanges between the supplicant, authenticator and the authentication server.
dot1x port-control {force-unauthorized | force-authorized | auto}
Use no dot1x port-control to set the authentication mode to be used on the specified port to auto.
auto
Interface Range mode added
Defines an interface range and accesses the Interface Range mode