Telnet Commands; Ip Telnet Maxsessions; Ip Telnet Timeout - Dell Force10 S2410-01-10GE-24P Command Reference Manual

ip address (routed)
show interface

Telnet Commands

This section describes the following SFTOS Telnet commands:
•
•
•
•
•
•
•
•

ip telnet maxsessions

This command specifies the maximum number of Telnet connection sessions that can be established.
ip telnet maxsessions 0-5
Syntax
A value of 0 indicates that no Telnet connection can be established. The range is 0 to 5.
The command no telnet maxsessions sets the maximum number of Telnet connection sessions that
can be established to the default value.
Default 5
Mode Global Config
Command
Version 2.3
History

ip telnet timeout

This command sets the Telnet connection session timeout value, in minutes. A session is active as long
as the session has been idle for the value set.
ip telnet timeout 1-160
Syntax
ip telnet maxsessions on page 71
ip telnet timeout on page 71
session-limit on page 72
session-timeout on page 72
show telnet on page 73
telnet on page 73
telnetcon maxsessions on page 73
telnetcon timeout on page 73
Changed from
Global Config.
Note:
Changing the timeout value for active sessions does not become effective until the
session is reaccessed. Any keystroke will also activate the new timeout duration.
Configures an IP address on a routed interface.
Displays a summary of statistics for a specific port, including
the management port, or a count of all CPU traffic based upon
the argument.
telnetcon maxsessions
and moved from Privileged Exec mode to
System Management Commands | 71