Show Switch - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Interface—Stack port number (A or B)
Diagnostic Entry1—80 character string used for diagnostics.
Diagnostic Entry—80 character string used for diagnostics.
Diagnostic Entry3—80 character string used for diagnostics.

show switch

This command displays information about all units in the stack or about a specified unit.
show switch [unit]
Syntax
Mode
User Exec; Privileged Exec
Example 1 Figure 12-78
Figure 12-78. Example of Output from the show switch Command on an S50
Force10 #show switch ?
<cr>
<unit>
Force10-S50 #show switch
Switch
------ ------------ ---------------- ---------------- --------------- --------
1
Force10-S50 #show switch 1
Switch............................ 1
Management Status................. Management Switch
Hardware Management Preference.... Unassigned
Admin Management Preference....... Unassigned
Switch Type....................... 0x56950201
Preconfigured Model Identifier.... SA-01-GE-48T
Plugged-in Model Identifier....... SA-01-GE-48T
Switch Status..................... OK
Switch Description................ Force10 48 port Gigabit S50
Expected Code Type................ 0x100b000
Detected Code Version............. F.9.15
Detected Code in Flash............ F.9.15
Serial Number..................... DE4541040
Up Time........................... 0 days 0 hrs 26 mins 37 secs
Force10-S50 #show switch 8
Switch 8 does not exist!
shows the output of both show switch and show switch unit-id for on an S50.
Press enter to execute the command.
Enter switch ID in the range of 1 to 8.
Management Preconfig
Status Model ID
Mgmt Switch SA-01-GE-48T
Plugged-in Switch
Model ID Status
SA-01-GE-48T OK
Code
Version
F2.5.1.0
Stacking Commands | 221