Match Ethertype; Match Any; Match Class-Map - Dell Force10 S2410-01-10GE-24P Command Reference Manual

match ethertype

Syntax
Mode

match any

Syntax
Default
Mode

match class-map

Syntax
Default
Mode
Restrictions
| Quality of Service (QoS) Commands
340
This command adds to the specified class definition a match condition based on the value of the
value is specified as one of the following keywords: appletalk, arp,
ethertype. The ethertype
ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp
custom ethertype value in the range of 0x0600–0xFFFF.
match ethertype {
keyword
Class Map (The prompt is "(Config-classmap)#".)
This command adds to the specified class definition a match condition whereby all packets are
considered to belong to the class.
match any
none
Class Map (The prompt is "(Config-classmap)#".)
This command adds to the specified class definition the set of match conditions defined for another
class.
The no version of this command removes from the specified class definition the set of match
conditions defined for another class.
[no] match class-map
refclassname
The is the name of an existing DiffServ class whose match conditions are being
refclassname
referenced by the specified class definition.
none
Class Map (The prompt is "(Config-classmap)#".)
The class types of both
classname
A class type of acl is not supported by this command.
Cannot specify
refclassname
allowed).
At most, one other class may be referenced by a class.
An attempt to delete the
refclassname
The combined match criteria of
on the class type. Any subsequent changes to the
validity, or the change attempt shall fail.
| custom
0x0600-0xFFFF }
and must be identical (i.e., any vs. any, or all vs. all).
refclassname
the same as (i.e., self-referencing of class name not
classname
class while still referenced by a
and
classname refclassname
refclassname
or as a
will fail.
classname
must be an allowed combination based
class match criteria must maintain this