System Management Commands; General System Management And Information Commands - Dell Force10 S2410-01-10GE-24P Command Reference Manual

System Management Commands

The commands in this chapter either manage the switch in general, configure management interfaces,
or show current management settings. For every configuration command, there is a nieA command
that displays the configuration setting.
This chapter contains the following major sections:
•
•
•
•

General System Management and Information Commands

This section describes the following commands:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
General System Management and Information Commands on page 35
Telnet Commands on page 71
remotecon maxsessions on page 73
SNMP Management Commands on page 77
Note: See also Chapter 6, "System Configuration Commands," on page 87
Chapter 9, "System Logs," on page
cx4-cable-length on page 36
dir on page 37
hostname on page 37
interface managementethernet on page 38
ip address (management) on page 38
mac-address on page 39
mac-type on page 39
management route default on page 40
network mac-address on page 41
network mac-type on page 41
network parms on page 41
network protocol on page 41
protocol on page 41
show arp switch on page 42
show cx4-cable-length on page 43
show ethernet
show hardware on page 46
show interface on page 47
show interface ethernet on page 50
show interface managementethernet on page 57
show interface switchport on page 59
169.
System Management Commands | 35
5
and