Protocol Lacp - Dell Force10 S2410-01-10GE-24P Command Reference Manual

port-security
This command is available in the Interface Port Channel Config mode.
See
port-security mac-address
This command is available in the Interface Port Channel Config mode.
See
port-security mac-address move
This command is available in the Interface Port Channel Config mode.
See
port-security max-dynamic
This command is available in the Interface Port Channel Config mode.
See
port-security max-static
This command is available in the Interface Port Channel Config mode.
See

protocol lacp

This command reenables the LACP on the selected LAG.
protocol lacp
Syntax
Default
enabled
Mode Interface Port Channel Config
Usage
By default, LACP is enabled, but, if the LAG has been converted to static, you can use this command
to revert the LAG to LACP mode.
Command
Version 2.5.1
History
Related
interface port-channel
Commands
port-security on page 183
port-security mac-address on page 184
port-security mac-address move on page 184
port-security max-dynamic on page 185
port-security max-static on page 185
in the Security Commands chapter.
in the Security Commands chapter.
in the Security Commands chapter.
in the Security Commands chapter.
in the Security Commands chapter.
Introduced, in the new Interface Port Channel Config mode, to replace
port-channel staticcapability.
Accesses the Interface Port Channel Config mode for the selected port
channel.
LAG/Port Channel Commands | 301